Small Form-Factor Pluggables for Cisco ISR1000.

Dying Gasp Through SNMP, Syslog, and Ethernet OAM.

Cisco Multimode G.SHDSL EFM-ATM in Cisco ISR 1000 Series Routers.

Cisco LTE/5G on Cisco 1000 Series Integrated Services Router.

Configuring VDSL2 and ADSL2/22 Plus for Cisco C1100 Series ISRs.

Setting Up Factory Default Device Using WebUI.

Console Port, Telnet, SSH Handling, and Reset Button.

Control Router Access with Passwords and Privilege Levels.

Cyber Attacks, Network Attacks, Threats and Mitigation.

DHCP Snooping Configuration on Packet Tracer.

Authentication, Authorization, Accounting (AAA).

Cisco RADIUS Server Configuration on Packet Tracer.

Radius Configuration for Wireless Users.

IPv6 Configuration on Cisco Packet Tracer.

IPv6 NDP (Neighbour Discovery Protocol).

IPv6 Static and Default Route Configuration.

Static NAT Configuration with Packet Tracer.

Dynamic NAT Configuration with Packet Tracer.

DHCP (Dynamic Host Configuration Protocol).

Router DHCP Configuration with Packet Tracer.

MLPPP Configuration on Cisco Packet Tracer.

OSPF(Open Shortest Path First) Overview.

OSPFv3 (Open Shortest Path First Version 3).

OSPFv3 Configuration Example on Cisco IOS.

Static Route Configuration on Cisco Routers.

Inter VLAN Routing with Router on Stick.

Switch Virtual Interface Configuration on Packet Tracer.

Inter VLAN Routing Configuration on Packet Tracer.

Link Aggregation Control Protocol (LACP).

STP Portfast Configuration with Packet Tracer.

STP (Spanning Tree Protocol) Example on Packet Tracer.

Portfast, Root Guard, BPDU Filter and BPDU Guard.

Loop Guard, Uplink Fast, Backbone Fast and UDLD.

VLAN Port Assignment and VLAN Port Types.

Cisco Packet Tracer VLAN Configuration Example.

DTP and VLAN Frame Tagging protocols ISL, dot1.q.

TCP Header : TCP Window Size, Checksum & Urgent Pointer.

TCP Header : Sequence & Acknowledgement Number.

ICMP (Internet Control Message Protocol).

Basic Cisco Router Configuration on Packet Tracer.

Ethernet Collisions and Troubleshooting.

So, we will see all the logs after this configuration.

For thsi example, we will set tap level as “ debug”. For example if you select Critical level (3), then Critical (3), Alert(2) and Emergency(1) Levels will be in the logs. Here, if you select any of these levels, all the other levels lover than it, will be showed in the logs. As you can see in the first Picture, there are 8 trap levels. This IP address will be the interface IP address of our Syslog Server. On Cisco routers, firstly we will enable syslog with “ logging on” command.Īfter that we will enter the Log Server IP address. These are the main Syslog configuration steps in a router.

In this step, we will configure 3 sub steps. You can also learn Packet Tracer DHCP Configuration

Example cisco packet tracer commands